Interference, Power factor. This video describes how to initialise your VLT frequency drive and reset all parameters to the default. Danfoss , literatuurnummer MG. Dit apparaat is via de modbus aangestuurd geweest en de lokale bedieningsfuncties zijn geblokkeerd.
Ik heb de handleiding maar de daarin aangegeven methodes om hem weer in de fabrieksinstelling te krijgen werken niet.
I am workign away from home at the moment overseas and have a time difference to my supplier. Anyone know where the setting is to initialise the drive back to the standard factory settings using the keypad? I have drives running nicely over ethernet to controllogix but my client wanted . Check that the mains supply has been disconnected and that the necessary time has passed before removing motor and mains plugs. Nodes at the physical ends of each segment must be terminated.
The factory setting is off. Please pay special attention to the pin-numbering vs.
PROFIBUS connector if exchanging the PROFIBUS connector. Setting of VLT parameters. During booting the VLT parameters are set to the factory settings. Only the motor parameters remain to be set:. The direction of rotation can be changed by switching two phases in the motor cable.
If the application is running in closed . If initializing is carried out (see parameter 620), the frequency converter returns to the factory setting. MAKING MODERN LIVING POSSIBLE. Document and Software Version. This manual is regularly reviewed and. When active and edit set-up differ, . The number flashing, indicates the edit set-up.
The small digits to the left are the selected parameter number. Indicating Selected Parameter . Factory recommended procedures, included in this manual, should be. Reset, Coasting stop, Reset and Coasting stop,.
Quick-stop, DC braking,. If this function is desire set 1-Motor Thermal Protection to data value. Do not remove the plugs for the motor and.
Geen opmerkingen:
Een reactie posten
Opmerking: Alleen leden van deze blog kunnen een reactie posten.